Kia Rio: Starter: Removal and Installation
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the air duct and air cleaner assembly. (Refer to EM group)
|
| 3. |
Disconnect the starter cable (B) from the B terminal on the solenoid
then disconnect the connector (A) from the S terminal.
|
| 4. |
Remove the 2 bolts holding the starter, then remove the starter
(A).
|
| 5. |
Installation is the reverse of removal.
|
Starter: Description
The starting system includes the battery, starter, solenoid switch, inhibitor
switch (A/T), ignition switch, ignition lock switch, connection wires and the
battery cable.
When the ignitio ...
Electric Oil Pump: Description
This transaxle has a standard Mechanical Oil Pump (MOP) linked to the
input shaft to generates oil pressure when input shaft rotates.
But, this transaxle equipped with ISG system also has ...
See also:
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mul ...
Ignition Coil: Description
An ignition coil is an induction coil in an engine's ignition system which
transforms the battery's low voltage to the high voltage needed to create an
electric spark in the spark plu ...
Temperature Control Actuator Description
The heater unit includes mode control actuator and temperature control
actuator.
The temperature control actuator is located at the heater unit. It regulates
the temperature by the proced ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026