Kia Rio: Sunroof Switch Inspection - Sun Roof - Body Electrical System - Kia Rio UB 2012-2019 Service ManualKia Rio: Sunroof Switch Inspection

1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the overhead console cover (A).


3.
After loosening the mounting screws, then remove the overhead console assembly (A).


4.
Check for continuity between the terminals. If the continuity is not as specified, replace the sunroof switch.
1. Ground
2. Switch A
3. Switch B
4. Switch C



Circuit Diagram
...

Sunroof Motor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - " Roof trim") ...

See also:

Rain Sensor Removal
   The rain sensor may not operate properly if contaminated. Protect the rain sensor surface by not removing the cover unti ...

Tilting the sunroof
To open the sunroof, push the sunroof control lever upward until the sunroof moves to the desired position. To close the sunroof, push the sunroof lever forward or pull downward until the sunroof ...

Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...

Copyright © www.kirmanual.com 2014-2019