Kia Rio: Transaxle Control Module (TCM) Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2021 Service ManualKia Rio: Transaxle Control Module (TCM) Installation

1.
Installation is reverse of removal.

     
In the case of the vehicle equipped with immobilizer or button engine start system, perform "Key Teaching" procedure together (Refer to "Immobilizer" or "Button Engine Start System in BE group).
Transaxle Control Module (TCM) Replacement
   When replacing the TCM, the vehicle equipped with immobilizer must be performed the procedure as below. [In the ...

Transaxle Oil Temperature Sensor Description
Transaxle oil temperature sensor monitors the automatic transaxle fluid's temperature and conveys the readings to TCM. It is an NTC (Negative Thermal Coefficient) sensor whose resistance ...

See also:

Emergency starting
Connect cables in numerical order and disconnect in reverse order. Jump starting Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicl ...

Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Inspection
1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

Copyright © www.kirmanual.com 2014-2021