Kia Rio: Transaxle Oil Temperature Sensor Description - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2019 Service ManualKia Rio: Transaxle Oil Temperature Sensor Description

Transaxle oil temperature sensor monitors the automatic transaxle fluid's temperature and conveys the readings to TCM. It is an NTC (Negative Thermal Coefficient) sensor whose resistance has an inversely proportional relationship with the temperature level. Data produced by this sensor is used to identify damper clutch activation and deactivation zones within the low temperature and high temperature range and to compensate hydraulic pressure levels during gear changes.

Transaxle Oil Temperature Sensor Specifications


Transaxle Control Module (TCM) Installation
1. Installation is reverse of removal.    In the case of the vehicle equipp ...

Transaxle Oil Temperature Sensor Specifications
▷ Type: Negative Thermal Coefficient Type Temp.[(°C)°F] Resistance (kΩ) (-40)-40 48.1 (-20)-4.0 15.6 (0)32.0 ...

See also:

Front Driveshaft Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...

Antenna Coil Installation
1. Install the antenna coil. 2. Connect the antenna coil connector. 3. Install the crash pad lower panel. ...

Troubleshooting
   • The battery must be in good condition and fully charged for this troubleshooting. ...

Copyright © www.kirmanual.com 2014-2019