Kia Rio Manuals

Kia Rio: Transaxle Oil Temperature Sensor Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2025 Service ManualKia Rio: Transaxle Oil Temperature Sensor Installation

1.
Installation is the reverse of removal.

     
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
•
The gasket of the valve body gasket (A) use new one.
•
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)
Transaxle Oil Temperature Sensor Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Input Speed Sensor Description
Input speed sensor (A) is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the TCM. The sensor provides critical input data ...

See also:

Ambient Temperature Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the engine room RH side under cover. (Refer to EM group - “Engine and Trans ...

Mode Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode con ...

Smart key unit Installation
Smart Key Unit 1. Install the smart key unit. 2. Install the smart key unit mounting nuts and connector. 3. ...

Categories

Copyright www.kirmanual.com 2014-2025