Kia Rio: Water pump: Inspection - Cooling System - Engine Mechanical System - Kia Rio UB 2012-2019 Service ManualKia Rio: Water pump: Inspection

1.
Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary.
2.
Check the bearing for damage, abnormal noise and sluggish rotation, and replace the coolant pump assembly if necessary.
3.
Check for coolant leakage. If coolant leaks from hole, the seal is defective. Replace the coolant pump assembly and gasket.

     
A small amount of УweepingФ from the bleed hole is normal.
Water pump: Removal and Installation
Water Pump 1. Drain engine coolant.    System is under high pre ...

Water pump: Troubleshooting
Water Pump Symptoms Possible Causes Remedy Coolant leakage Х From the bleed hole of the water pump ...

See also:

Fuel Filler Cap
Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap an ...

SS-B Solenoid Valve(ON/OFF) Description
SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

Valve Body Components Location
1. PCV adjust screw 2. Solenoid valve 3. Oil temperature sensor 4. Accumulator 5. Low & reverse brake(LR/B) pressure flow hole 6. Under drive brake (UD/B) pressur ...

Copyright © www.kirmanual.com 2014-2019