Kia Rio: 26 Brake Control Solenoid Valve(26/B_VFS) Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the solenoid valve connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

26 Brake Control Solenoid Valve(26/B_VFS) Circuit Diagram

...

26 Brake Control Solenoid Valve(26/B_VFS) Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

See also:

Hands free mic Inspection
1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") ...

Front Fog Lamps Removal
1. Disconnect the negative (-) battery terminal. 2. Disconnect the fog lamp connector (A). 3. Remove t ...

Vehicle parasitic current inspection
1. Turn the all electric devices OFF, and then turn the ignition switch OFF. 2. Close all doors except the engine hood, and then lock all d ...

Categories

Copyright © www.kirmanual.com 2014-2026