Kia Rio: Adjustment
| ETC module learning procedure |
When installing new ETC module or re-installing it, ETC module learning
procedure must be performed.
| 1. |
Hold the ignition key or the start button at the IG ON position
during 5 seconds.
|
| 2. |
Turn ignition swich OFF and then start the engine.
|
DTC codes (P0638, P2110) might be displayed if ETC module learning
procedure does not performed after replacing ETC module.
|
Installation
•
Install the component with the specified torques.
•
...
See also:
Specification
Ignition System
Ignition Coil
Item
Specification
Primary Coil Resistance (Ω)
0.75 ± 15％ [20°C (68°F)]
Secondary Coi ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification:
...
General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before starting
work.
The s ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026