Kia Rio: AGM Battery: Specification - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: AGM Battery: Specification

Item
Specification
Model type
AGM 70L-DIN
Capacity [20HR/5HR] (AH)
70/56
Cold Cranking Amperage (A)
760 (SAE) / 610 (EN)
Reserve capacity (Min)
120



     
Model type description
Cold Cranking Ampere (CCA): Cold Cranking Amps is a rating used in the battery industry to define a battery's ability to start an engine in cold temperatures.
-
The rating is the number of amps a new, fully charged battery can deliver at -18 °C(-0.4 °F) for 30 seconds, while maintaining a voltage of at least 7.2 volts for a 12 volt battery.
-
The higher the CCA rating, the greater the starting power of the battery.
RESERVE CAPACITY (RC) : Reserve Capacity is a battery industry rating, defining a battery's ability to power a vehicle with an inoperative alternator or fan belt.
-
The rating is the number of minutes a battery at 26.7 °C(80 °F) can be discharged at 25 amps and maintain a voltage of 10.5 volts for a 12 volt battery.
-
The higher the reserve rating, the longer your vehicle can operate should your alternator or fan belt fail.
AGM Battery: Description
AGM battery is used for especially heavy load on the vehicle network depending on equipment and requirements. AGM stands for Absorbent Glass Material Battery; that is absorbent glass fibre fl ...

AGM Battery: Adjustment
Battery charging In general, vehicle battery charging system has three forms. 1. Constant current charge: The battery voltage gradually rises by chargi ...

See also:

Relay Box (Passenger Compartment) Installation
1. Install the interior junction box. 2. Install the crash pad lower panel. 3. Check that all system operates n ...

Parking brake
Checking the parking brake Check the stroke of the parking brake by counting the number of “clicks’’ heard while fully applying it from the released position. Also, the parking brake alone ...

Front Impact Sensor (FIS) Description
The front impact sensor (FIS) is installed in the front side member. They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the F ...

Copyright www.kirmanual.com 2014-2026