Kia Rio Manuals

Kia Rio: Anchor Pretensioner (APT) Installation - Seat Belt Pretensioner - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Anchor Pretensioner (APT) Installation

1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at least thirty seconds.
3.
Install the anchor pretensioner with a bolt.
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
4.
Connect the anchor pretensioner connector.
5.
Install the center pillar trim.
(Refer to the Body group - "Interior trim")
6.
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
7.
Insert the seat belt to the anchor pretensioner (A).



     
Make sure the lock pin is connected in properly.
8.
Reconnect the battery negative cable.
9.
After installing the anchor pretensioner, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Anchor Pretensioner (APT) Removal
1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the seat belt after pushin ...

Brake System
...

See also:

Description
Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens or ...

Compressor Description
The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of engine. The compressor changes the low pressure and low temperature r ...

Vehicle parasitic current inspection
1. Turn the all electric devices OFF, and then turn the ignition switch OFF. 2. Close all doors except the engine hood, and then lock all d ...

Categories

Copyright www.kirmanual.com 2014-2026