Kia Rio: Anchor Pretensioner (APT) Removal - Seat Belt Pretensioner - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Anchor Pretensioner (APT) Removal

1.
Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work.
2.
Remove the seat belt after pushing the lock pin (A).


3.
Remove the door scuff trim.
(Refer to the Body group - "Interior trim")
4.
Remove the center pillar trim.
(Refer to the Body group - "Interior trim")
5.
Disconnect the anchor pretensioner connector (A).


6.
Loosen the anchor pretensioner mounting bolt (B) and remove the anchor pretensioner.
Anchor Pretensioner (APT) Components
...

Anchor Pretensioner (APT) Installation
1. Remove ignition key from the vehicle. 2. Disconnect the negative (-) cable from battery and wait for at least thirty seconds. ...

See also:

Compressor Removal
1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. ...

Component Location (2)
[4 Door] 1. Back up lamp 2. Turn signal lamp 3. Tail lamp/ Stop lamp 4. Tail lamp 5. Stop lamp 6. Side marker lamp 7. High mounted stop lamp 8. Lic ...

Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop ...

Copyright © www.kirmanual.com 2014-2026