Kia Rio: Auto Defogging Sensor (FATC only) Replacement| 1. |
Remove the auto defogging sensor cover (A).
|
| 2. |
Disconnect the connector (B) and then remove the auto defogging
sensor (C).
|
| 3. |
Install in the reverse order of removal.
|
Auto Defogging Sensor (FATC only) Inspection
Cluster Ionizer (FATC only) DescriptionSteering Column and Shaft Adjustment
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below and if abnormal symp ...
Power Mosfet (FATC) Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of
blower motor.
3.
...
Components
1. Cylinder block
2. Ladder frame
3. Crankshaft
4. Crankshaft upper bearing
5. Crankshaft lower bearing
6. Thrust bearing
7. Main bearing cap
8. Adapter plate
...