Kia Rio: Auto Light Sensor Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the photo & auto light sensor (A) from crash pad upper
side by using screw (-) driver.
|
| 3. |
Remove the auto light connector.
|
Auto Light Sensor Inspection
In the state of IGN1 ON, when multi function switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto light sensor ...
Auto Light Sensor Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
...
See also:
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Description
Underdrive brake control solenoid valve(UD/B_VFS) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the underdrive brake.
...
Service Standard
Item
Specification
Ignition Timing (°)
BTDC 3 ± 10
Idle Speed (rpm)
A/C OFF
Neutral, N, P-range
630 ± 100
D-rang ...
TPMS Receiver Description
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this
state. ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026