Kia Rio: Auto Light Sensor Installation - Auto Lighting Control System - Body Electrical System - Kia Rio UB 2012-2024 Service ManualKia Rio: Auto Light Sensor Installation

1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
Auto Light Sensor Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the photo & auto light sensor (A) from crash pad upper side by using screw ( ...

Head lamp leveling Device
...

See also:

Line Pressure Control Solenoid Valve Specifications
Direct control VFS[LINE Pressure] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) Current ...

Hazard warning flasher   lighting
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as po ...

Engine compartment
1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake/clutch fluid reservoir 4. Air cleaner 5. Fuse box 6. Positive battery terminal 7. Negative battery terminal 8. Windshield washer ...

Copyright © www.kirmanual.com 2014-2024