Kia Rio: Back-up Lamp Switch Replacement - Manual Transaxle Components - Manual Transaxle System - Kia Rio UB 2012-2026 Service ManualKia Rio: Back-up Lamp Switch Replacement

1.
Disconnect the back up lamp switch connector (A).


2.
Remove the back up lamp switch (A).


3.
Replace a new one and install the back up lamp switch.

Tightening torque:
29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)

Back-up Lamp Switch Inspection
1. Disconnect the back up lamp switch connector (A). 2. Check the continuity between no. 1 and 2 terminals of backup lamp switch. W ...

Automatic Transaxle System
...

See also:

Relay Box (Engine Compartment) Inspection
Replacement of EMS box 1. Disconnect the negative (-) battery terminal. 2. Push hooks in the engine room relay box out to the arrow directio ...

BCM connectors
Pin No. Connector A Connector B Connector C 1 Battery (+) K_LINE Turn signal switch (RH) 2 Ignition 2 Centr ...

On-vehicle Inpection
   • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accord ...

Copyright www.kirmanual.com 2014-2026