Kia Rio: Back-up Lamp Switch Specifications

Back-up Lamp Switch Description

Back up lamp switch is pushed by the reverse lug sliding when select arm, and switches the back up lamp. ...

Back-up Lamp Switch Inspection

1. Disconnect the back up lamp switch connector (A). 2. Check the continuity between no. 1 and 2 terminals of backup lamp switch. W ...

See also:

Rear Hub - Carrier Replacement
[Drum Type] 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Installation
1. Dowel pin of crankshaft setted about 3° with vertical center line. 2. Align the TDC marks (A) of the CVVT sprockets with the upper s ...

Rain Sensor Inspection
Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the ...