Kia Rio: Blower Motor Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad and heater & blower unit assembly.
(Refer to HA group – “Heater Unit”)
|
| 3. |
Disconnect the blower motor connector (A).
|
| 4. |
Remove the blower motor (A) after loosening the screws.
|
| 5. |
Install in the reverse order of removal.
|
Blower Motor Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a know ...
Blower Resistor (MANUAL) Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
See also:
Adjustment
Battery Sensor Recalibration Procedure
If disconnecting the negative (-) battery cable from the battery during
repair work for the vehicle equipped with Alternator Managing Syst ...
License Lamp Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the license lamp lens by pushing the clip (A).
3.
...
Passenger Airbag (PAB) Module Removal
1.
Disconnect the battery negative cable and wait for at least thirty
seconds before beginning work.
2.
Remove the glove box housing.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026