Kia Rio Manuals

Kia Rio: Passenger Airbag (PAB) Module Removal - Airbag Module - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Passenger Airbag (PAB) Module Removal

1.
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
2.
Remove the glove box housing.
(Refer to the Body group - "Crash pad")
3.
Disconnect the passenger airbag connector (B) and remove the PAB mounting bolt (A).
4.
Remove the crash pad.
(Refer to the Body group - "Crash pad")

     
If the PAB has been deployed, replace the damaged crash pad.
5.
Remove the heater duct from the crash pad.
6.
Remove the mounting bolts from the crash pad. And then remove the passenger airbag.

     
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.
Passenger Airbag (PAB) Module Components
...

Passenger Airbag (PAB) ModuleInstallation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least thirty seconds bef ...

See also:

SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new unit, the “Variant Coding” procedure must be performed.    1. ...

Installation
   • Install the component with the specified torques. • ...

Components Location
1. Engine Control Module (ECM) 2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) 4. Engine Coolant Temperature Sensor (ECTS) 5. Throttle Po ...

Categories

Copyright www.kirmanual.com 2014-2026