Kia Rio: Blower Unit Replacement - Blower - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2026 Service ManualKia Rio: Blower Unit Replacement

1.
Remove the heater & blower unit.
(Refer to HA group - "Heater Unit")
2.
Separate the blower unit from the heater unit after loosening the screws.



     
Make sure that there is no air leaking out of the blower and duct joints.
3.
Install in the reverse order of removal.
Blower Unit Components
1. Blower Motor 2. Blower Fan 3. Clamp 4. NVH Pad 5. Connection Case 6. Cluster Ionizer (FATC only) 7. Intake Case (Left) 8. Intake Seal 9. NVH Pad 10. Intake ...

Blower Motor Inspection
1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a know ...

See also:

Receiver-Drier Replacement
1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with L wrench (A). Tightening torq ...

Installation
1. Installation is in reverse order of removal. ...

Hazard Lamp Switch Installation
1. Connect the connectors. 2. Install the hazard lamp switch. 3. Connect the negative (-) battery terminal. ...

Copyright www.kirmanual.com 2014-2026