Kia Rio: Component(2) - Multifunction switch - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Component(2)

Inspection


Component(1)
※ Installation order : A → B → C → D → E 1. Steering column shaft 2. Lighting switch 3. Wiper and washer switch 4. Screw 5. Steering angle ...

Inspection
Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

See also:

Air bag warning light
The purpose of the air bag warning light in your instrument panel is to alert you of a potential problem with your air bag-Supplemental Restraint System (SRS). When the ignition switch is turned O ...

Installation
1. Install the intake CVVT (A) and exhaust CVVT (B). Tightening torque : 63.7 ~ 73.5 N.m (6.5 ~ 7.5 kgf.m, 47.0 ~ 54.2 lb-ft) ...

Front Wheel Speed Sensor Inspection
1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground.    ...

Copyright www.kirmanual.com 2014-2026