Kia Rio: Inspection

Lighting Switch Inspection

With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch.

Lighting switch (Auto Light)

Lighting switch

HS : Head lamp switch(Short inside)

Dimmer And Passing Switch

Turn Signal Switch

Front Fog Lamp Switch

Wiper And Washer Switch Inspection

With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch.

Wiper Switch (Intermittent)

Washer Switch

Rear wiper switch

Rear washer switch

Component(2)

...

Removal

Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to the ST group - &qu ...

See also:

Measuring Body Dimensions
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Front Wiper Motor Removal
1. Loosen the windshield wiper arm nut (A) after removing a wiper cap (B). 2. Remove the windshield wiper arm and blade. ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS termi ...