Kia Rio: Compressor Removal
| 1. |
If the compressor is marginally operable, run the engine at idle
speed, and let the air conditioning work for a few minutes, then shut
the engine off.
|
| 2. |
Disconnect the negative cable from the battery.
|
| 3. |
Recover the refrigerant with a recovery/charging station.
|
| 4. |
Remove the RH front tire.
(Refer to SS group - “Front Tire”)
|
| 5. |
Remove the engine room RH side under cover.
(Refer to EM group - “Engine and Transaxle Assembly”)
|
| 6. |
Separate the front portion of the front wheel guard (A) from the
wheel house.
|
| 7. |
Loosen the drive belt.
(Refer to EM group - “Timing Chain”)
|
| 8. |
Disconnect the suction line (A) and discharge line (B) from the
compressor.
|
| 9. |
Disconnect the compressor switch connector (A).
|
| 10. |
Remove the compressor by loosening the mounting bolts.
|
Compressor Components
1. Center Bolt
2. Hub Bolt
3. Hub Assembly
4. Snap Ring
5. Pulley
6. Compressor Assembly
7. Electric Control Valve (ECV)
...
Compressor Installation
1.
Make sure of the length of compressor mounting bolts, and then
tighten it with the specified tightening order.
Tightening torque :
...
See also:
Special Service Tools
Tool (Number and name)
Illustration
Use
09977-25100
Disc & hub assembly bolt remover
Removal and installation of disc & hub assembly ...
Removal
When replacing the ECM, the vehicle equipped with immobilizer
must be performed the procedure as below.
...
Description
-
EPS (Electronic Power Steering, Column assist type) system uses
an electric motor to assist the steering force and it is an engine operation
independent steering system ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026