Kia Rio: Description
Back view camera will activate when the backup light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through
the ECM (Reverse Display Room Mirror) mirror or AVN head unit while backing-up.
This system is a supplementary function only. It is the responsibility
of the driver or always check the inside/ outside rearview mirror and
the area behind the vehicle before and while backing up because there
is a dead zone that can't see through the camera.
|
Circuit Diagram
...
Removal
1.
Remove the trunk trim in the trunk after removing the screws and
clips.
(Refer to the BD group - "Tailgate")
2.
Remove ...
See also:
TJ Joint Inspection
1.
Check the spider assembly for roller rotation, wear or corrosion.
2.
Check the groove inside the joint case for wear or corrosion
...
Air bag collision sensors
(1) SRS control module
(2) Front impact sensor
(3) Side impact sensor
WARNING - Air bag sensors
Do not hit or allow any objects to impact the locations where air bag
or sensors are installed ...
ECM Terminal And Input/Output signal [A/T]
ECM Terminal Function (A/T)
Connector [EGGA-AG]
Pin No.
Description
Connected to
1
Injector (Cylinder #1) [High] control output
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026