1. |
Inspect diaphragm spring wear which is in contact with a concentric
slave cylinder bearing.
|
2. |
Check the clutch cover and disc surface for wear or cracks.
|
3. |
Check the clutch disc lining for slipping or oil marks.
|
4. |
Measure the depth from a clutch lining surface to a rivet. If
the measured value is less than the specification below, replace it.
|
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Components
1. Clutch release fork
2. Clutch cover assembly
3. Clutch disk assembly
4. Clutch release bearing
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the manifold absolute pressure sensor connecto ...