Kia Rio: Description

Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance with the air/fuel ratio.

The sensor must be hot in order to operate normally. To keep it hot, the sensor has a heater which is controlled by the ECM via a duty cycle signal. When the exhaust gas temperature is lower than the specified value, the heater warms the sensor tip.

Heated Oxygen Sensor (HO2S)

...

Specification

HO2S [Bank 1/Sensor 1] Item Specification Heater Resistance (Ω) 2.4 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2] A/F Ratio (λ) ...

See also:

Line Pressure Control Solenoid Valve Inspection
1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

Troubleshooting
Symptom Suspect Area Remedy (Refer to page) Water leaks from sunroof Dirt accumulated in drain tube Clear dirt inside of drain Clogged drai ...

Rear Bumper Replacement
[5 Door]    • Put on gloves to protect your hands. • ...