Kia Rio: Description
TREAD Lamp
| - |
Tire Under Inflation / Leak Warning.
|
|
1. |
Turn on condition
| A. |
When tire pressure is below allowed threshold
|
| B. |
When rapid leak is detected by the sensor.
|
| C. |
Indicates that tire needs to be re-inflated to placard
pressure / repaired.
|
|
|
2. |
Turn off condition
| A. |
Under-inflation ; When tire pressure is above (warning
threshold + hysteresis).
|
| B. |
Rapid Leak ; When tire pressure is above (leak warning
threshold).
|
|
DTC Warning
|
1. |
Turn on condition
| A. |
When the system detects a fault that is external to the
receiver/ sensor.
|
| B. |
When the system detects a receiver fault.
|
| C. |
When the system detects a sensor fault.
|
|
|
2. |
Turn off condition
| A. |
If the fault is considered as 'critical', then the lamp
is held on throughout the current Ignition cycle (even if the
DTC has been demoted). This is because it is important to bring
the problem to the drivers attention. On the following Ignition
cycle, the demotion conditions will be re-checked. If the demotion
conditions occur, the lamp will be turned off. It will be held
on until DTC demotion checking is completed.
|
| B. |
'Non critical' faults are those that can occur temporarily
e.g. vehicle battery under voltage. The lamp is therefore turned
off when the DTC demotion condition occurs.
|
|
System Fault
|
1. |
General Function
| A. |
The system monitors a number of inputs across time in
order to determine that a fault exists.
|
| B. |
Faults are prioritized according to which has the most
likely cause.
|
| C. |
Maximum fault store is equal to 15.
|
| D. |
Certain faults are not covered through DTC. The main ones
are:
|
| 1) |
Sensor thermal shutdown (over 257°F/125°C).
|
| 2) |
Ignition Line stuck ; requires observation of
lamps at Ignition ON to diagnose.
|
|
|
Hamess Connector
Pin No.
Discription
Remark
1
-
2
-
3
-
4
...
1.
Mode
(1)
Normal Fixed Base State
A.
Sensor transmissions continue at the Low Line
...
See also:
Speakers Inspection
1.
Troubleshooting for Speaker
(1)
Basic inspection of speaker
Inspect the sound from speaker after verifying that the
s ...
Ignition Coil: Description
An ignition coil is an induction coil in an engine's ignition system which
transforms the battery's low voltage to the high voltage needed to create an
electric spark in the spark plu ...
Component Location (3)
[5 Door]
1. Back up lamp
2. Turn signal lamp
3. Tail lamp/ Stop lamp
4. Tail lamp
5. Stop lamp
6. Side marker lamp
7. High mounted stop lamp
8. Lic ...
Circuit Diagram
TPMS Sensor Description