Kia Rio: Disassembly
|
Identify MLA(Mechanical lash adjuster), valves, valve springs
as they are removed so that each item can be reinstalled in its original
position.
|
|
1. |
Remove the mechanical lash adjusters (MLAs) (A).
|
When removing MLAs, mark all the MLAs for their rearrangement.
|
|
|
2. |
Remove the valves.
|
(1) |
Using the SST (09222 - 3K000, 09222 - 3K100), compress
the valve spring and remove the retainer lock.
|
|
(2) |
Remove the spring retainer.
|
|
(3) |
Remove the valve spring.
|
|
(5) |
Remove the valve stem seal.
|
|
(6) |
Using a magnetic finger, remove the spring seat.
|
Do not reuse the valve stem seals.
|
|
|
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging ...
Cylinder Head
1.
Inspect for flatness.
Using a precision straight edge and feeler gauge, measure the
surface the contacting the cylinder block and the manifolds ...
See also:
Door Switch Installation
1.
Install is reverse of removal.
...
Thermostat: Components
1. Water inlet fitting
2. Thermostat
3. Heater pipe
4. Water temp control assembly
5. Water temperature sensor
6. Gasket
...
Specification
Engine
T/M
Joint type
Max. permissible angle
Outer
Inner
Outer
Inner
Gasoline 1.6
MT, AT
BJ#82
TJ#82
...
Removal
Inspection