Kia Rio: Driver Airbag (DAB) Module and Clock Spring Inspection - Airbag Module - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Driver Airbag (DAB) Module and Clock Spring Inspection

Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace the airbag module with a new one.

     
Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.
1.
Check pad cover for dents, cracks or deformities.
2.
Check the airbag module for denting, cracking or deformation.
3.
Check hooks and connectors for damage, terminals for deformities, and harness for binds.
4.
Check airbag inflator case for dents, cracks or deformities.


5.
Install the airbag module to the steering wheel to check for fit or alignment with the wheel.
Clock Spring
1.
If, as a result of the following checks, even one abnormal point is discovered, replace the clock spring with a new one.
2.
Check connectors and protective tube for damage, and terminals for deformities.


Driver Airbag (DAB) Module and Clock Spring Removal
1. Set the front tires straight-ahead before removing the steering wheel.    ...

Driver Airbag (DAB) Module and Clock Spring Installation
1. Set the front tires straight-ahead before assembling the steering wheel.    ...

See also:

Component Location
1. Head cap 2. Nut 3. Rear wiper arm & Blade 4. Packing (rubber) 5. Rear wiper motor assembly 6. Bolt ...

Cruise Control Switch: Inspection
Measuring Resistance 1. Disconnect the cruise control switch connector from the control switch. 2. Measure resistance between t ...

Compression Pressure Inspection
   If there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. ...

Copyright www.kirmanual.com 2014-2026