Kia Rio: Driving your vehicle - Kia Rio UB 2012-2024 Owners ManualKia Rio: Driving your vehicle

Be sure the exhaust system does not leak.

The exhaust system should be checked whenever the vehicle is raised to change the oil or for any other purpose. If you hear a change in the sound of the exhaust or if you drive over something that strikes the underneath side of the car, have the exhaust system checked as soon as possible by an authorized Kia dealer.

WARNING - Engine exhaust

Do not inhale exhaust fumes or leave your engine running in a enclosed area for a prolonged time. Exhaust fumes contain carbon monoxide, a colorless, odorless gas that can cause unconsciousness and death by asphyxiation.

WARNING - Open tailgate

Do not drive with the tailgate open. Poisonous exhaust gases can enter the passenger compartment If you must drive with the tailgate open proceed as follows: Close all windows. Open side vents. Set the air intake control at "Fresh", the air flow control at "Floor" or "Face" and the fan at the highest speed.

WARNING - California proposition 65

Engine exhaust and a wide variety of automobile components and parts, including components found in the interior furnishings in a vehicle, contain or emit chemicals known to the State of California to cause cancer and birth defects and reproductive harm. In addition, certain fluids contained in vehicles and certain products of component wear contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

Ending voice recognition
While Voice Recognition is operating Press and hold the key on the steering remote controller (over 0.8 seconds) While using voice command, pressing any steering wheel control or a differen ...

Before driving
Before entering vehicle Be sure that all windows, outside mirror(s), and outside lights are clean. Check the condition of the tires. Check under the vehicle for any sign of leaks. Be sure th ...

See also:

Weight Classification System (WCS) Components
...

Input/ Output Description
Function I/O Connector No Description Active Remark Power B+ A1 Supply power to BCM Power   ...

Fuel Pump Inspection
[Fuel pump] 1. Turn ignition switch OFF and disconnect the negative (-)battery cable. 2. Remove the fuel pump assembly. ...

Copyright © www.kirmanual.com 2014-2024