Kia Rio Manuals

Kia Rio: Dynamic Damper Replacement - Driveshaft Assembly - Driveshaft and axle - Kia Rio UB 2012-2026 Service ManualKia Rio: Dynamic Damper Replacement

1.
Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”)
2.
Remove the TJ joint assembly. (Refer to DS group - “TJ joint”)
3.
Remove the remove the both side of band (B) of the dynamic damper (A).
4.
Fix the driveshaft (A) with a vice (B) as illustrated.
5.
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper when the dynamic damper is removed.
6.
Seperate the dynamic damper (A) from the shaft (B) carefully.
Dynamic Damper Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

Dynamic Damper Installation
1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

See also:

Removal
1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to the BD group - "Tailgate") 2. Remove ...

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Spe ...

Front Seat Replacement
   • When removing or installing the front passenger seat, be sure to initialize the Weig ...

Categories

Copyright www.kirmanual.com 2014-2026