Kia Rio Manuals

Kia Rio: Dynamic Damper Installation - Driveshaft Assembly - Driveshaft and axle - Kia Rio UB 2012-2026 Service ManualKia Rio: Dynamic Damper Installation

1.
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
3.
Install the dynamic damper band.
4.
Using the SST(09495-3K000), secure the TJ boot bands (A).
Clearance (A): 2.0 mm (0.079 in) or less


5.
Install the TJ joint assembly. (Refer to DS group - “TJ joint”)
6.
Install the front driveshaft. (Refer to DS group - “Front Driveshaft”)
Dynamic Damper Replacement
1. Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to DS group - “TJ joint ...

BJ Boot Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

See also:

Front Impact Sensor (FIS) Removal
   • Removal of the airbag must be performed according to the precautions/ procedures des ...

Filler-Neck Assembly Removal
1. Open the fuel filler door, and then remove the filler-neck assembly mounting screws (A). 2. Disconnect the fuel filler hose (A) ...

Front Stabilizer Link Replacement
1. Remove the rear wheel & tire Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Categories

Copyright www.kirmanual.com 2014-2026