Kia Rio: Electric Oil Pump: Removal - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Electric Oil Pump: Removal

1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the Electric Oil Pump (EOP) connector (A).


3.
Remove the under cover (A) after lifting the vehicle with lift.


4.
Remove the Electric Oil Pump (B) after removing the bolts (A-4ea).

Tightening torque:
19.6 ~ 25.5 N.m (2.0 ~ 2.6 kgf.m, 14.4 ~ 18.8 lb-ft)



Electric Oil Pump: Circuit Diagram
...

Electric Oil Pump: Installation
1. Installation is the reverse of removal. ...

See also:

Display settings
Press the key Select [Display] through TUNE knob or key Select menu through TUNE knob Mode Pop up [Mode Pop up] Changes / selection mode During On state, press the or key to d ...

ESC Control Module Removal
1. Turn ignition switch OFF. 2. Pull up the lock of the HECU connector (A), and then disconnect the connector. ...

Power Door Lock Switch Removal
1. Disconnect the negative(-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front door") ...

Copyright www.kirmanual.com 2014-2026