Kia Rio Manuals

Kia Rio: Fender Replacement - Exterior - Body (Interior and Exterior) - Kia Rio UB 2012-2026 Service ManualKia Rio: Fender Replacement


     
•
When removing and installing the fender, an assistant is necessary.
•
Be careful not to damage the fender and body.
•
When removing the clips, use a clip remover.
1.
Remove the front bumper cover.
(Refer to the BD group – “Front bumper”)
2.
Remove the head lamps.
(Refer to the BE group – “Head Lamps”)
3.
Using a screwdriver or remover, remove the front pillar trim (A).
4.
Disconnect the tweeter speaker connector (A).
5.
Loosen the delta glass mounting nuts.
Tightening torque :
3.9 ~ 4.4 N.m (0.4 ~ 0.45 kgf.m, 2.9 ~ 3.3 lb-ft)


6.
Remove the delta glass (A).
7.
Loosen the wheel guard (A) mounting screws.
8.
After loosening the mounting screws, then remove the front bumper side mounting bracket (A).
9.
After loosening the mounting bolts, then remove the fender assembly (A).
10.
Installation is the reverse of removal.
Exterior
...

Hood Replacement
Hood Assembly Replacement    • When removing and installing the hood, an assistant is ...

See also:

Vehicle load limit
Tire and loading information label The label located on the driver's door sill gives the original tire size, cold tire pressures recommended for your vehicle, the number of people that can be ...

Input Speed Sensor Specifications
▷ Type: Hall effect sensor Operation condition [°C(°F)] ((-)40 ~ 150)) -40 ~ 302 Air gap(mm)in. (1.2 ~ 1.8) 0.0472 ~ 0.0709 Output vol ...

Child restraint system
Children riding in the car should sit in the rear seat and must always be properly restrained to minimize the risk of injury in an accident, sudden stop or sudden maneuver. According to accident s ...

Categories

Copyright www.kirmanual.com 2014-2026