Kia Rio: Front Bumper Replacement - Bumper - Body (Interior and Exterior) - Kia Rio UB 2012-2024 Service ManualKia Rio: Front Bumper Replacement


     
Х
Put on gloves to protect your hands.
Х
Use a plastic panel removal tool to remove interior trip pieces to without marring the surface.
Х
Take care not bend or scratch the cover and other parts.
1.
After loosening the mounting clips, then remove the radiator grille upper cover (A).


2.
Loosen the front bumper upper (A) mounting clips.


3.
After loosening the front bumper sideТs mounting screw, then disconnect the sideТs.


4.
Remove the front bumper lower mounting clips.


5.
Disconnect the fog lamp connector (A).


6.
Remove the front bumper cover (A).


7.
Installation is the reverse of removal.

     
Х
Make sure the connector is plugged in properly.
Х
Replace any damage clips.
Front Bumper Components
1 . Radiator grille upper cover 2 . Front bumper cover 3 . Front bumper side bracket [LH] 4 . Front bumper side bracket [RH] ...

Rear Bumper Components
[5 Door] 1. Rear bumper cover 2. Rear bumper side bracket [RH] 3. Rear bumper side bracket [LH] 4. Rear bumper side under cover [4 Door] ...

See also:

Compressor Installation
1. Make sure of the length of compressor mounting bolts, and then tighten it with the specified tightening order. Tightening torque : ...

Component Location (2)
[4 Door] 1. Back up lamp 2. Turn signal lamp 3. Tail lamp/ Stop lamp 4. Tail lamp 5. Stop lamp 6. Side marker lamp 7. High mounted stop lamp 8. Lic ...

Engine coolant
The high-pressure cooling system has a reservoir filled with year-round antifreeze coolant. The reservoir is filled at the factory. Check the antifreeze protection and coolant level at least once a ...

Copyright © www.kirmanual.com 2014-2024