Kia Rio: Front Fog Lamps Inspection - Lighting System - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Front Fog Lamps Inspection

Multifunction Switch(Lighting)
1.
Disconnect the negative(-) battery terminal.
2.
Remove the lighting switch of the multi-function switch. (Refer to the multifunction switch)
3.
With the front fog lamp switch, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.


Front Fog Lamp Switch

High Mounted stop lamp Removal


Front Fog Lamps Installation
1. Install the fog lamp. 2. Reconnect the fog lamp connector. 3. Connect the negative (-) battery terminal. ...

High Mounted stop lamp Removal
[4 Door] 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connect (A). 3. Remove ...

See also:

Rear Wheel Alignment
   When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always p ...

Rear Shock Absorber Components
   • Must completely be tigtened at the curb position of vehicle when assemble shock ...

Hazard warning flasher   lighting
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as po ...

Copyright www.kirmanual.com 2014-2026