Kia Rio Manuals

Kia Rio: Function - Keyless Entry And Burglar Alarm - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Function

Keyless Entry Function
DOOR LOCK / UNLOCK are performed with remote controller.
1.
Keyless entry function is performed in a state that key in switch is eliminated from key cylinder
2.
LOCK / UNLOCK signals are received from the transmitter and DOOR LOCK / UNLOCK signals are output.
Transmitter(TX) Spec
1.
Transmission Distance : 10m or more from outside of the car
2.
Registration procedure of the transmitter
(1)
In registration mode, it shall be possible to register up to Max 4EA.
(2)
At re-registration, data are registered newly after deleting the previous TX DATA
No.
 Saved CODE
 CODE to change
 Changed CODE
1
 None
 A
 A
2
 A
 B
 B(A is deleted)
3
 B
 C,D
 C,D(B is deleted)
4
 C,D
 E,F,G
 E,F,G(C,D is deleted)
5
 E,F,G
 H,I,J,K
 H,I,J,K(E,F,G is deleted)
6
 A,B
 C,D,E,F,G
 C,D,E,F
7
 A,B
 C,C,D,E,F
 C,D,E
8
 A,B,C,D
 A
 A
9
 A,B,C,D
 E
 E

(3)
For the registration procedures by using Diagnostic tester, refer to "TRANSMITTER CODE REGISTRATION".
3.
Transmitter signal & Receiver specification
(1)
Transmission signal
A.
Transmit relevant transmission DATA (Transmission frame) twice by pushing TX SW.
B.
Only LOCK signal is output when pushing TX LOCK switch and UNLOCK switch at the same time.
Description
Keyless Entry System The keyless entry system allows you to lock and unlock the vehicle with the remote transmitter. When you push the LOCK button, all doors lock. When you push the UNLOC ...

Inspection
Front Door Lock Actuator and Switch 1. Remove the front door trim. (Refer to the Body group - Front door) 2. Remove the front door l ...

See also:

Inspection
1. After disconnecting the vapor hose from the PCV valve, remove the PCV valve. 2. Reconnect the PCV valve to the vapor hose. ...

SS-A Solenoid Valve(ON/OFF) Description
SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed at valve body. ...

Cluster Ionizer (FATC only) Inspection
1. Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch. Display Fail description 00 ...

Categories

Copyright www.kirmanual.com 2014-2026