Kia Rio: Hands free switch Removal - Hands free switch Schematic Diagrams - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Hands free switch Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to the RT group - "DAB and Clock spring")
3.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
4.
Remove 2 screws on the steering wheel.


5.
Remove the steering wheel cover (A) after loosening 6 screws.


6.
Remove the hands free switch.
Hands free switch Inspection
1. Check the hands free remote control switch for resistance between No.4 and No.5 terminals in each switch position. Audio + Bluetooth [LH] ...

Hands free switch Installation
1. Reassemble the hands free switch after connecting the connector. 2. Reassemble the steering wheel. 3. Reasse ...

See also:

Component Location
1. Driver power window main switch 2. Passenger power window switch 3. Front window motor 4. Rear window motor 5. Rear window switch ...

TPMS Receiver Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Compressor Disassembly
1. Remove the RH front tire. (Refer to SS group - “Front Tire”) 2. Remove the engine room RH side under cover. (Refer to EM ...

Copyright www.kirmanual.com 2014-2026