1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the heater & A/C controller (A) from the center facia using
a flat-head screwdriver or remover.
|
3. |
Disconnect the connectors (A).
|
4. |
Install in the reverse order of removal.
|
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Direct control VFS[35R/C]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42)
Current value(mA ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
Washer fluid
Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available.
However, use washer sol ...