Kia Rio: Inspection
| 1. |
After disconnecting the vapor hose from the PCV valve, remove
the PCV valve.
|
| 2. |
Reconnect the PCV valve to the vapor hose.
|
| 3. |
Run the engine at idle, then put a finger over the open end of
the PCV valve and make sure that intake manifold vacuum can be felt.
|
| 4. |
If the vacuum is not felt inspect PCV operation, if operating
correctly clean or replace the vapor hose.
|
See also:
Shift Lever Adjustment
1.
In neutral position, disjoin select cable (A) from shift lever
assembly pin (B).
2.
Disconnect select adjuster (A) to an arrow.
...
Component Location
1. PCB fuse & relay box (Head lamp low/ hi, Fuel pump #1, HAC,
Engine control, Front wiper, Rain sensor, Blower, Cooling fan low/ hi, Horn,
Buglar alarm horn, Start relay)
...
Heater & A/C Control Unit (FATC) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater & A/C controller (A) from the center facia using
a flat-head scre ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026