Kia Rio Manuals

Kia Rio: Inspection - Specification - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Inspection

Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Specification: Refer to “Specification”
ETC Motor
1.
Turn the ignition switch OFF.
2.
Disconnect the ETC module connector.
3.
Measure resistance between the ETC module terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Circuit Diagram
(M/T) (A/T) ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer to ...

See also:

SS-A Solenoid Valve(ON/OFF) Installation
1. Installation is the reverse of removal.    • When installing ...

Roll Over Valve (ROV): Repair procedures
Removal 1. Remove the fuel pump. (Refer to Engine Control/Fuel System - “Fuel Pump”) 2. Remove the roll over valve (A) after relea ...

Description
Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine ...

Categories

Copyright www.kirmanual.com 2014-2026