Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the resonator and the air intake hose (Refer to “Intake
And Exhaust System” in EM group).
|
| 3. |
Disconnect the ETC module connector (A).
|
| 4. |
Disconnect the coolant hoses (A).
|
| 5. |
Remove the installation bolts, and then remove the ETC module
(A) from the engine.
|
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TP ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Head lamp leveling Actuator Installation
1.
Install the head lamp leveling actuator by turning the adjusting
gear.
2.
Install the head lamp assembly.
3.
...
Ignition Switch Assembly Inspection
1.
Disconnect the ignition switch connector (B) and key switch connector
(A) from under the steering column.
2.
Check for continui ...
Driver Airbag (DAB) Module and Clock Spring Components
1. Driver Airbag (DAB)
2. Steering Wheel
3. Clock Spring
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026