Kia Rio: Inspection
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Remove the ECTS (Refer to "Removal").
|
| 3. |
After immersing the thermistor of the sensor into engine coolant,
measure resistance between the ECTS terminals 3 and 4.
|
| 4. |
Check that the resistance is within the specification.
|
Circuit Diagram
(M/T)
(A/T)
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
See also:
Rear Torsion Beam Axle Replacement
[Disc Type]
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Instrument Cluster Inspection
Speedometer
1.
Adjust the pressure of the tires to the specified level.
2.
Drive the vehicle onto a speedometer tester. Use wheel chocks
...
Shift Lever Removal
Shift Lever Assembly Replacement
1.
Remove the center console.
(Refer to "interior (console)" in BD group)
2.
Di ...
Copyright © www.kirmanual.com 2014-2025