1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Turn the ignition switch ON.
|
3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
|
Starter: Components
1. Screw
2. Front housing
3. Stop ring
4. Stopper
5. Overunn clutch
6. Lever
7. Lever plate
8. Lever packing
9. Magnet switch assembly
10. Armature assemb ...
Installation
•
Install the component with the specified torques.
•
...
DC/DC Converter: Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
Without battery sensor :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ ...