Kia Rio Manuals

Kia Rio: Input Speed Sensor Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2026 Service ManualKia Rio: Input Speed Sensor Installation

1.
Installation is the reverse of removal.

     
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
•
The gasket of the valve body gasket (A) use new one.
•
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)
Input Speed Sensor Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Output Speed Sensor Description
The output speed sensor (A) is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the TCM. The sensor provides ...

See also:

BJ Boot Replacement
1. Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to DS group - “TJ Joint ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description
Overdrive clutch control solenoid valve(OD/C_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the overdrive clutch. ...

Back-up Lamp Switch Description
Back up lamp switch is pushed by the reverse lug sliding when select arm, and switches the back up lamp. ...

Categories

Copyright www.kirmanual.com 2014-2026