Kia Rio: Inspection

Removal

1. Turn ignition switch OFF, and disconnect the negative (-) battery cable. 2. Remove the battery and ECM. (Refer to Engine Electr ...

Installation

1. Installation is the reverse of removal.    A. ...

See also:

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: ...

Compressor Installation
1. Make sure of the length of compressor mounting bolts, and then tighten it with the specified tightening order. Tightening torque : ...

Rear Hub - Carrier Replacement
[Drum Type] 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...