Kia Rio: Installation

1.

Installation is the reverse of removal.

A.	Before installing the pin, apply the grease to the joint pin.

B.	Use a new snap pin whenever installing.

2.	After installing, bleed the brake system. (Refer to Brake system bleeding)

3.	Adjust the brake pedal height and free play. (Refer to Brake pedal height and free play adjustment)

Inspection

1. Inspect the check valve in the vacuum hose. Do not remove the check va ...

Master Cylinder

...

See also:

DC/DC Converter: Circuit Diagram
In the ISG mode, if the power of an audio system turnsOFF by drawdown while â€œAuto Startingâ€ or â€œIdle Startingâ ...

Heater Unit Components
1. Shower Duct (Left) 2. Heater Pipe Cover 3. Mode Control Actuator 4. Mode Control Actuator Bracket 5. Defog mode lever (FATC) 6. Mode Control Main Lever (MANUAL) 7. Vent ...

Description
TREAD Lamp - Tire Under Inflation / Leak Warning. 1. Turn on condition A. When tire pressure is below a ...

Categories

Copyright © www.kirmanual.com 2014-2026