Kia Rio: Installation - Multifunction switch - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Installation

Multifunction Switch
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steering column upper and lower shrouds.
4.
Install the steering wheel.

     
Make sure the multifunction switch connectors are plugged in properly.
Removal
Wiper and Washer Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to the ST group - &qu ...

Horn
...

See also:

Description
Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on various engin ...

Smart key unit Circuit diagram
No. Connector A(26 pins) No. Connector B(16 pins) No. Connector C(22 pins) 1 VBAT_LOAD 1 C_CAN_L 1 O_S ...

SS-A Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12)  Internal resistance(&# ...

Copyright www.kirmanual.com 2014-2026