Kia Rio: Removal
Wiper and Washer Switch
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
|
| 3. |
Remove the steering column upper (A) and lower (B) shrouds after
removing the screw.
|
| 4. |
Disconnect the connector(A). Release the lock of wiper switch
using tool without removing the steering wheel and the clock spring.
Remove the wiper and washer switch.
|
Multifunction Switch Assembly
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
|
| 3. |
Remove the steering column upper and lower shrouds after removing
3 screws.
|
| 4. |
Remove the clock spring.
(Refer to the RT group - "Airbag module")
|
| 5. |
Disconnect the lighting switch connector and wiper & washer switch
connector.
Remove the multifunction switch assembly (A) after loosening 2
mounting screws.
|
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mul ...
Installation
Multifunction Switch
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steer ...
See also:
Starting the engine
WARNING - Proper footwear
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes
(high heels, ski boots, sandals, etc.) may interfere with your ability to use the
brake and a ...
Brake Booster Vacuum Pressure Sensor: Circuit Diagram
...
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026