Kia Rio Manuals

Kia Rio: Installation - DC DC Converter - Charging System - Engine Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Installation

1.
Install in the reverse order of removal.

     
•
After reconnecting the battery negative cable, ISG function dose not operates until the system is stabilized, about 4 hours.
If disconnecting the negative (-) battery cable from the battery during repair work for the vehicle equipped with ISG function, Battery sensor recalibration procedure should be performed after finishing the repair work.
(Refer to Charging System - "Battery Sensor")
Removal
1. Disconnect the battery negative terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box Housing") ...

Battery
...

See also:

Engine overheat
If your temperature gauge indicates overheating, you will experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1.Pull off the ...

Specifications
Transaxle type M6CF1 Engine type Gasoline 1.6 GDI Gear ratio 1st 3.769 2nd 2.045 3rd 1.286 ...

Rear Coil Spring Replacement
1. Remove the rear wheel & tire. (Both RH side and LH side) Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb ...

Categories

Copyright www.kirmanual.com 2014-2026