Kia Rio: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
|
1. |
Installation is reverse of removal.
Knock sensor installation bolt:
18.6 ~ 24.5 N.m (1.9 ~ 2.5 kgf.m, 13.7 ~ 18.1 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the intake manifold (Refer to “Intake And Exhaus ...
See also:
Heater Unit Components
1. Shower Duct (Left)
2. Heater Pipe Cover
3. Mode Control Actuator
4. Mode Control Actuator Bracket
5. Defog mode lever (FATC)
6. Mode Control Main Lever (MANUAL)
7. Vent ...
Removal
1.
Disconnect the battery negative terminal.
2.
Disconnect the air compressor connector (A) and the alternator
connector (B), and remove th ...
Cleaning
1.
Make sure the ignition switch and all accessories are in the OFF
position.
2.
Disconnect the battery cables (negative first).
...
Removal
